From 7594cbd9024de96fa4af204b5d4082e775765474 Mon Sep 17 00:00:00 2001 From: Tim Ansell Date: Fri, 22 Feb 2019 14:57:07 -0800 Subject: [PATCH] Fixing images in README in iCE40-hx8k_breakout_board_xip directory too. --- scripts/Murax/iCE40-hx8k_breakout_board_xip/README.md | 6 ++++-- 1 file changed, 4 insertions(+), 2 deletions(-) diff --git a/scripts/Murax/iCE40-hx8k_breakout_board_xip/README.md b/scripts/Murax/iCE40-hx8k_breakout_board_xip/README.md index 62078a3..1e50a02 100644 --- a/scripts/Murax/iCE40-hx8k_breakout_board_xip/README.md +++ b/scripts/Murax/iCE40-hx8k_breakout_board_xip/README.md @@ -2,7 +2,8 @@ This example is for the [Lattice iCE40HX-8K Breakout Board](http://www.latticesemi.com/Products/DevelopmentBoardsAndKits/iCE40HX8KBreakoutBoard.aspx). An image of this board is shown below; -![img/iCE40HX8K-breakout-revA.png] + +![`iCE40HX8K breakout revA`](img/iCE40HX8K-breakout-revA.png) This board can be purchased for ~$USD 49 directly from Lattice and is supported by the IceStorm @@ -20,7 +21,8 @@ mode. This requires removing jumper `J7` and putting the pair of jumpers on This is shown in **Figure 5** of the [iCE40HX-8K Breakout Board User Guide](http://www.latticesemi.com/view_document?document_id=50373). which is also reproduced below; -![img/cram-programming-config.png] + +![CRAM Programming Config](img/cram-programming-config.png) Once your board is ready, you should follow the setup instructions at the [top level](../../../README.md).