Florent Kermarrec
|
2e1a816d1f
|
pano_logic_g2: switch to LiteEthPHY and simplify Ethernet/Etherbone.
|
2020-05-29 10:41:35 +02:00 |
|
Florent Kermarrec
|
2f3817cba9
|
pano_logic_g2: add ethernet (build but not functional yet) and use user_btn_n as sys_rst.
|
2020-05-27 10:13:12 +02:00 |
|
Florent Kermarrec
|
f19bc36813
|
pano_logic_g2: add revision support (b and c, c as default) and add OpenOCD programmer.
Tested with:
./pano_logic_g2.py --uart-name=jtag_uart --build --load
./litex_jtag_uart.py --config=openocd_xc6_ft232.cfg
lxterm /dev/pts/X
|
2020-05-27 08:58:40 +02:00 |
|
Florent Kermarrec
|
22f18f618e
|
pano_logic_g2: move gmii_rst_n to _CRG.
|
2020-05-26 08:36:06 +02:00 |
Skip Hansen
|
1ab46562bd
|
Take Ethernet PHY out of reset so default clock is 125 Mhz (and baud rate is 115,200)
|
2020-05-25 10:11:03 -07:00 |
|
Florent Kermarrec
|
eeba64d7b2
|
targets: use soc.build_name in load/flash bitstream.
|
2020-05-21 09:12:29 +02:00 |
|
Florent Kermarrec
|
6f22f082ff
|
targets: add LedChaser on platforms with user_leds.
Default to Chaser mode and similar user interface than GPIOOut.
|
2020-05-08 22:16:13 +02:00 |
|
Florent Kermarrec
|
19b12fd984
|
targets/panol_logic_g2: replace with a minimal target.
|
2020-05-07 16:36:04 +02:00 |
|
Florent Kermarrec
|
6b5492a707
|
pano_logic_g2: add copyrights.
|
2020-05-07 15:24:03 +02:00 |
|
Florent Kermarrec
|
6ddd859309
|
add pano_logic_g2 from litex-buildenv.
|
2020-05-07 15:22:22 +02:00 |