UART Transmitter
~~~~~~~~~~~~~~~~~~
This UART transmitter on the basys3 board.
.. code-block:: bash
:name: additional-example
cd additional_examples
Then run make to compile the design:
.. code-block:: bash
:name: example-uarttx-basys3
make -C uart_transmitter
At completion, the bitstream is located in the build directory:
.. code-block:: bash
cd uart_transmitter/build/arty_35
Now, you can upload the design with:
.. code-block:: bash
openocd -f ${INSTALL_DIR}/${FPGA_FAM}/conda/envs/${FPGA_FAM}/share/openocd/scripts/board/digilent_arty.cfg -c "init; pld load 0 top.bit; exit"
Once the code has been downloaded to the board open a Putty terminal and choose the serial connection line for your board.
Also set the baud rate to 19200, data bits to 8, stop bits to 1, the parity to ODD, and the flow control to NONE. You can
change these properties by looking under the serial settings on the left hand side.
After configuring Putty, open a session and use the switches on the basys to chose an `ASKII <https://www.asciitable.com/>`_
character to send over UART. The value of the character will be displayed on the seven segment display in hexadecimal and
you can send the character over UART by pressing the center button. The following is an example of the transmitter:
.. image:: ../images/uart_tx.gif
:align: center
:width: 50%
bbffe02635