Re-generating the SoC/Software headers was causing some un-expected behaviours for users not familiar
with the flow. For example doing a --load with a different configuration, was re-generating the Software
headers and messing up things when trying to run software on the SoC.
Moving CRG simplify reset with NaxRiscv debug module and is in fact more logical.
Also do some minor updates/cosmetic changes while touching CRG/SoCCore.
CPU parameters are now selectively exposed to the user:
./digilent_arty.py --cpu-type=vexriscv_smp --help will show VexRiscv-SMP parameters.
./digilent_arty.py --cpu-type=naxriscv --help will show NaxRiscv parameters.
Setting MASTER_SPI_PORT=SERIAL causes the SPI flash pins to be reserved
for use by the sysCONFIG logic, and prevents user logic from assigning
them. This made it impossible to have a Litex design which accesses the
SPI flash on this board.
Remove the setting, so that we get the default behaviour which permits
user logic to assign these pins. In the unlikely event that someone
needs the pins to stay reserved for sysCONFIG after configuration (I'm
not sure why this would be needed) they could explicitly add this
command in their design.
This board is documented as having the LIFCL-40-9BG400C part, but some
versions of the board exist which were fitted with LIFCL-40-8BG400CES,
an engineering sample part. The distinction is important because the
engineering sample requires a different device ID to be embedded in the
bitstream. If you try to build a bitstream for LIFCL-40-9BG400C and load
it onto LIFCL-40-8BG400CES the configuration fails (indicated by the red
"INITN" LED on this board).
Accept --device to allow the user to specify which FPGA part their board
has.
- main_ram mem_map is now directly used by add_sdram when origin is None.
- max_sdram_size/min_l2_data_width are no longer exposed as targets arguments this can
still be used enforced directly in the few cases it is useful.
Florent Kermarrec
Gwenhael Goavec-Merou
slagernate
Dan Callaghan
Joey Bushagour